HEATER CORE REMOVAL
1963-64 Fairlane
Disconnect defroster tubes and heater hoses at heater. It is necessary to remove glove box on 1964 models. Remove heater retaining nuts on engine side of cowl. From inside of car, disconnect rubber boot, at fresh air inlet, then disconnect control cables at heater. To gain access to core, remove heater and separate to halves of heater housng.
1965-66 Fairlane
The heater core is mounted in the heater case in a diagonal position in the center of the case and is serviced through an opening in the back plate. With the heater assembly out of the vehicle, simply remove four screws from the cover plate and pull the core from the housing. The core is mounted in the heater housing with rubber pads oil each end to insure a snug fit.
1967-69 Fairlane
1. Drain cooling system and disconnect both heater hoses at dash.
2. Unfasten heater from dash.
3. Disconnect temperature and defroster cables at heater.
4. Disconnect wires from resistor, and blower motor wires and clip retaining heater to defroster nozzle.
5. Remove glove box.
6. Remove bolt and nut retaining right air duct control to instrument panel.
7. Remove nuts retaining right air duct and remove duct.
8. Take heater assembly to bench. Then remove heater core cover and pad and lift out core.
This Page is Part of Fast Fairlane Site
Disconnect defroster tubes and heater hoses at heater. It is necessary to remove glove box on 1964 models. Remove heater retaining nuts on engine side of cowl. From inside of car, disconnect rubber boot, at fresh air inlet, then disconnect control cables at heater. To gain access to core, remove heater and separate to halves of heater housng.
1965-66 Fairlane
The heater core is mounted in the heater case in a diagonal position in the center of the case and is serviced through an opening in the back plate. With the heater assembly out of the vehicle, simply remove four screws from the cover plate and pull the core from the housing. The core is mounted in the heater housing with rubber pads oil each end to insure a snug fit.
1967-69 Fairlane
1. Drain cooling system and disconnect both heater hoses at dash.
2. Unfasten heater from dash.
3. Disconnect temperature and defroster cables at heater.
4. Disconnect wires from resistor, and blower motor wires and clip retaining heater to defroster nozzle.
5. Remove glove box.
6. Remove bolt and nut retaining right air duct control to instrument panel.
7. Remove nuts retaining right air duct and remove duct.
8. Take heater assembly to bench. Then remove heater core cover and pad and lift out core.